Product Model:
SMR1006-DCN3215Li
15A for 1-2 series lithium battery
SMR1006DC3225Li
25A for 1-2 series lithium battery
Parameters:
Product Introduction:
SMART-DC series 3.2v/6.4V solar street light charge controllers support max 15V solar panel, and can support max 20W lamp. Its self-consumption is only 9Ma. IP67, very good performance water-proof function. When BMS power off because of LVD, it can activate the system automatically.
◆Controller employs components that tend to produce arcs or sparks. NEVER install in battery compartment or in the presence of explosive gases.
◆Protect all wiring from physical damage, vibration and excessive heat.
◆Ensure that the controller is properly setup for the battery being charged. uDo not expose the controller to rain or snow.
◆Ensure all terminating connections are clean and tight to prevent arcing and overheating.
◆Charging system must be properly installed as described in these instructions prior to operation.
◆Do not connect to a PV array capable of producing greater than 40 amps of short circuit current @ 25°C.
◆Do not connect input to DC source directly with load, Solar Charge Controller need to .be powered by solar panel.
◆Never charge a frozen battery.
◆Be sure battery is mounted in a well-ventilated compartment.
◆Add distilled water in each cell until battery acid reaches level specified by battery manufacturer. This helps purge excessive gas from the cells. Do not overfill. For a battery without cell caps, carefully follow manufacturers charging instructions.
 |  |
Hot Tags: 3.2v 6.4v solar street light controller, China 3.2v 6.4v solar street light controller manufacturers, top notch goods, over discharge protection mppt solar charge controller, long lasting item, solar charge controller for solar heater, budget friendly product, magnetic offer
